212 - Use of Hospital Facilities

[..]

I know that one of the key point of this problem is

Code: Select all

A recovery room bed is only available if the preparation is already finished when the patient leaves surgery.

I think I can handle this rule well (and so as other requirement), but get WA.
I checked that the input doesn't zero as number input, this makes more confused as I can't find where is my bug........ Any hint from anyone accepted?? Thanks

[Adrian Kuegel]

You can send me your code if you want and I will check it.
I hope I didn't make a mistake when I generated the judge output (the input is most probably correct, I used a lot of asserts to ensure it).

[sclo]

There shouldn't be any problems with the judge output, although it is quite tricky to get AC for this problem.

[aadelf]

The sample output is correct, but I keep getting an Wrong Answer result.
However I did not understand the part, where the next sample input is read.

while (scanf("%d %d %d %d %d %d %d",&nr,&nb,&sh,&mTrans,&mPreO, &mPreRe,&N)!=EOF){
......

}

Is this correct?

Every single character seems to be right?

What else could be wrong?

[dull_jester]

Code: Select all

If two patients emerge from surgery at the same time, the patient with
the lower number will be the  first assigned to a recovery room bed. (If in addition the two patients
entered surgery at the same time, the one  first on the roster is  first assigned a bed.)

Here, "lower number" means lower number of the operation room. OK, I understand that. But what to make out of the sentence in brackets? ON Spoj, the sentence in brackets is not given, yet people somehow manage to get Accepted there.

[dull_jester]

Are there multiple runs? So, what is the input format? What is the exact format if numPatients = 100? 100 won't fit into two columns, but two columns for patient ID number is what is shown in sample I/O.

[anacharsis]

Are there multiple runs? So, what is the input format? What is the exact format if numPatients = 100? 100 won't fit into two columns, but two columns for patient ID number is what is shown in sample I/O.

I have the same questions.
The problem description states expressly that there is only one input set - but then the sample input at UDebug has multiples...